Access control electric locks wiring methods
Release date:2016-01-13
This article is to explain the access control electric locks wiring method, first electric mortise lock is an electronic control locks, driven off by the current, "tongue" in extended or retracted or open the door to reach the lock function. Of course, implementation requires close door function with "floppy" fit can be achieved.
Access control electric locks wiring methods
In the case of the selection of electric locks for the AE2511 power locks, power locks the eight-wire protruding tails are red, black, blue, white, yellow, green, gray, orange lead eight colors, red for the power locks Power supply (+) line, then DC12V 12V power supply or controlled power line, black for negative power supply electric lock, then the electric lock source (-), blue, white, yellow line for the cylinder state detection, blue is normally open (NO), white as the common point (COM), yellow is a normally closed (NC) (Figure 1), when the lock cylinder pops up often closed to open, normally open on. Green, gray, orange line door detection line, detection line is in the OFF or ON state, the green is normally open (NO), gray as the common point (COM), orange is normally closed (NC) (Figure 2 ), normally open position after the door was closed and a normally closed on state conversion.
Power locks wiring diagram shown in Figure 3, received when installing electric lock power cord must be of DC12V. Power locks with adjustable delay, the so-called delay means from the lock open, people will enter the length of time after the door is closed again locked electric locks, power locks located in the middle of the adjustment jumper lock delay time can be varied, Methods A total of third gear set 0 seconds, 2.5 seconds, 5 seconds.
Previous:Without